What is a flexible resin plate making machine? What is the operation method of the flexible resin plate making machine?

What is a flexible resin plate making machine, which belongs to one type of printing equipment, is mainly used in the plate making process, and has certain peculiarities, mainly using a flexible resin as a plate making raw material.

Flexible resin plate making machine operation method:

1, adjust the brush

Inject water or fresh solvent into the water tank at a height of 1cm from the top of the brush. Lightly brush the brush by hand to make the brush evenly soaked. Then cover the cover. After stopping for 1 second, open the cover and check the glass on the flat plate. Traces of water stains require uniform distribution of water stains. If uneven, adjust the four spring-loaded screws around the brush plate until the glass on the top of the brush and the flat plate are evenly leveled. After the brush is adjusted, drain the water, plug in the power, turn on the power switch, and press the red POWER button.

2, back exposure

Set the exposure time, open the exposure drawer, put the cut flexible version, put the back side up on the exposure pumping, the center of the suction plate in the drawer, gently push the exposure drawer, set the exposure time, press the exposure switch Key, the exposure begins. When the exposure time is up, the digital tube number stops beating, returning from 000.0 to the exposure time you set, and there is a “嘀” prompt to end the exposure.

3, exposure

Pull the exposure drawer open, roll up the vacuum film, and expose the back flexo-flexive version, tearing the upper layer protection one at a time, layering, face up in the center of the suction plate in the exposure drawer. Put the film of the film face down on the plate, the area of the plate must be slightly larger than the area of the film, cover the plate and the place where the film is touched with a gas guide of 1~2cm wide. The gas guide can be washed without water. The material can't let the gas guide cover the content of the film! Open the vacuum switch key and spread the rolled vacuum film evenly on the film. From the center to the periphery, wipe the small air between the film and the plate. Bubble, note: Be sure to smash multiple times! Any bubbles between the film and the plate will cause the exposure to fail.

Article source address: http://